19 cfm Gas Engine Compressor/Generator

Reciprocating Compressors

Combination Packages

19 cfm Gas Engine Compressor/Generator

IG Industrial-duty gas and diesel compressors are designed for applications that require air on the go. Built for durability and reliability with features designed to make these compressors simpler to use and easier to maintain than any other compressor in this class. The engine is standard on the drivers side of the vehicle. The unloader is at your finger tips so you can unload the compressor before starting to increase solenoid and starter life. The transfer tube is protected by the receiver for saftey.

With the capacity to run 1-inch impact wrenches along with any assortment of air tools, this is the compressor you need to get the job done.

Features
19 cfm @ 175 psi
5000 Watt Generator
No Start-Up Kit Required
Optional 5-Year Pump Warranty
Access to compressor valves without compressor head removal
Alternator on drive engine
ASME tested powder coated steel tank
Bearings on both ends of the crank shaft
Centrifugal unloader
Critical controls protected by compressor base plate
Disk and spring valves
Drive engine on left side for safety
Fully enclosed belt guard
Full saddle mounting feet instead of pegged mounting feet
Heavy-duty air filter
Heavy-duty two-stage solid cast iron pump
Industrial-duty engine
Needle bearings, and inserts on rods
Pilot valve continuous operation
Swedish steel valves
Torrington needle bearings
2-grove B width drive pulley

Generator Features
110/220 volt outlets
41 amps @ 120 volt}
20 amps @ 240 volt}

Platinum Model Features
Automatic tank drain
Belt guard aftercooler
On-board battery mounted and wired (No truck wiring needed)
Tank discharge ball valve
Vibration pads
Freight pre-paid in the 48 states & southern Canada

Air-cooled aftercooler on all Platinum units

Model	HP	Mount	Tank	Drive Engine	Length	Width	Height	Weight
CI13GEH30-GEN	13	Tank Mount	30 Gallon Horizontal	Honda	44	22	42	550
CI14GEK30-GEN	14	Tank Mount	30 Gallon Horizontal	Honda	44	22	42	550
Add -P after model number to make Platinum model